Mounting elements for RIZURBOX-C and RIZURBOX-M enclosures

Mounting elements are used both for installation of the enclosures themselves (on-site in the required position) and the protected equipment inside them.
1 - fastening for a flange
2 - fastening for a weldolet
3 - heating tube
4 - tube adapter
5 - floor-stand
6 - mounting pad
7 - insulation adapter
8 - clamp with a welded flange
9 - clamp for a horizontal tube
10 - mounting panel
11 - mounting clip
12 - mounting rail

Intended use and application area

Mounting elements are used both for installation of the enclosures themselves (on-site in the required position) and the protected equipment inside them.
Mounting clips (11) attached to the bottom or back surface are used for the installation of the enclosure on a horizontal or vertical surface.
Floor-stand (5) with a mounting pad (6) attached are used in order to install the enclosure at a certain distance from a horizontal surface.
A special fastening (2) is used for the mounting of small enclosures, such as Rizur-Box-C-Multi.
Big enclosures are mounted onto the pipelines with the help of the clamps for a horizontal tube (9). In this case, the weldolet enters the enclosure through the opening in its bottom surface.
Heating enclosures with diagonal, horizontal, and vertical openings are mounted to pipelines with the help of clamps with welded flanges (8).
An insulation adapter (7) is used to ensure thermal insulation of the cable glands for the impulse lines.
If the enclosure is to be heated with hot water/steam then a heating tube (3) should be placed inside.
Mounting rails (12), mounting panels (10), and tube adapters (4) are used to install equipment inside the enclosure.
Some other mounting elements can be used depending on specific technical requirements.
Яндекс.Метрика
0
Send request